Hi again,
So I replaced the yoke and driven disk but it still hesitates in first gear. What is the correct way to setup the tension between the driven disc and the drive disc pulley from the engine? Where should the gear shift be when I adjust everything and how much of a gap if any? Thanks
So I have an issue with my 3311x5s. When I put it in 1st gear it won't move. Second gear it moves but very very slow. Reverse works good. I have no idea where to start. There is gear oil in the case... I just received a yoke that I haven't installed yet...
So I have an issue with my 3311x5s. When I put it in 1st gear it won't move. Second gear it moves but very very slow. Reverse works good. I have no idea where to start. There is gear oil in the case... I just received a yoke that I haven't installed yet...
Here are the updated pictures of the mower model in question. I'm hoping by showing the mowing deck it will help you all better to identify the exact model.
Snapper 33" hivac.... was mowing and the left side went up into a concrete pad and the blade started hitting the deck as I continued. Blade on one side now is touching the bottom of the deck but the other side doesn't. Even put a new blade on and the 1 side still touches the deck when I spin...
I have a Briggs and Stratton 12hp for an old snapper 33" hi vac 3311X5S and I can't find any numbers for the electrical starter. Anyone know how I go about finding a correct replacement
I have an old snapper 33" hi vac 3311X5S and I'm looking for a place online that sells a replacement cutting blade. What's the best blade to go with for a good looking lawn and also so the grass won't clump? A direct link to a blade would be greatly appreciated.