Tiger Small Engine's latest activity

I say hone it very lightly, then re-ring it and run it. Boring to oversize is impractical and very expensive to do in a machine shop...

The hard push by corporate America, the government, and media for battery powered outdoor power equipment and electric vehicles has been...

Lets start with the actual 7 digit model number from the model number tag since there are 17 different models of the IS500Z. And then...

Transaxles don’t go out often. They also don’t just suddenly quit if they are hydrostatic. They slowly start failing. Cost prohibitive...

Gator blades.

Oh boy you would need some very deep pockets. You are better off just buying a factory built electric mower if you wish to change from...

Shuts down as if you turn off the key doesn't sound like fuel issue to me. Loss of fuel issue normally will spit and sputter a few...

Folks we can blame the CEO, the stock holders or who ever we want but the American buying public is to blame for 2+ decades the cry has...

I use Permatex Right Stuff and have had great results with it.

Right stuff is a great sealer that is not too difficult to fight with later, the drawback is that it is expensive.

Adjusting the valves every 50-100 hours is unnecessary. Many of my customers don’t adjust the valves ever. The 300 hour recommendation...

Kbowey, are you still around on this forum? Haven't seen you chime in much recently. Hope you return. You are an intelligent valued...

Use a heat gun to soften up the RTV. Use a drill with a wire brush to remove the RTV.

It looks a lot like a tank ventilation problem, try opening the cap slightly to see if that changes anything. I've had the same problem...

Follow the hydro bypass rod back to the hydro transaxle and look at it and push/pull it back and forth and see if it has full travel...