Recent content by Rugb

Does anyone know if an HH70 piston,will work in place of an HH60 piston , if you bore it out? Thanks

Yes it should have the number on the base on the right hand side, but nothing there for some reason?? Anyway I called a dealer and he said it most likely should have the letters and numbers following the FJ 180V as “AM18” So I engraved them all there for future reference Thanks

Looked all over again and don’t see any tag or numbers on the right side. Looked on the front, valve cover etc, looked on the left side all around. Don’t think I would have to take the shroud off? Strange I can’t find anything ? https://postimg.cc/Hr7L05Q9/e51f724e

https://postimg.cc/0MNckjgm/dcc55dab

Wanting to order carb parts for this mower, but can’t see any model on the only tag I see? Assume this is a FJ180V? But what would the suffix letters/ numbers be for this mower? Trying to attach a photo of the tag, but keeps saying my file is too large

Working on a customers saw and one problem is is puts out an awful lot of oil on the chain. Too much! Is there any way to slow that down? I don’t see an adjuster, anything that can be done to help that problem? Thanks

Thanks for your help. Putting it together yesterday after being apart for several weeks, I got confused. Mostly because I was looking for a small hole in the throttle shaft near the clip. This was how the older springs connected to take up all the play in the rod between the governor arm and...

Uploaded the pictures but that’s as far as I could figure it out, too complicated for an old person

Greetings I’m putting the carb back on, after its been off a while, and have a question as to where the spring on the linkage from the governor to throttle shaft connects? Sometimes there is a hole in the throttle shaft, but don’t have a hole. Does it connect to the little clip that holds...

Rebuilding the Kawasaki FD 620D and so far haven’t been able to find any spec tag or numbers stamped in anywhere?? I’m up to ordering parts and if I don’t go thru the dealer, I need to have numbers more than fd620d. Seems there are 2 connecting rod numbers I come up with and maybe there are...

Putting a CV740 together today, doing an overhaul. Got to where I'm putting the flywheel and coils on. Turn it over to where a cylinder is at or before TDC where you would expect the 'spark' to happen. Ok, but what I find is at that point the magnet on the flywheel is way! past the coil, like 5...

I can't seem to find the model number on this 2 Cylinder engine ,or where would it be stamped in? It is used on a SR1000 Country Clipper Charger model mower. I'm thinking it is about a 26 hp. Its a vertical shaft and 83 mm bore, carbureted That is about all I know on it right now. Anyone know...

Have a cv14s Kohler with a spec of 1445. Trying to look for some parts and trying on line to find this model and spec. But always come up with the cv14 without the "s" with the 1445 spec number. What does the "s" mean or does it make any difference in the parts? Thanks