Rivets's latest activity

  • R
    Rivets replied to the thread X140 not charging.
    Please post all engine numbers and we should be able to find you an individual parts list and possibly a service manual.
  • R
    Try this troubleshooting procedure I’ve posted many times. Electrical problems can be very easy or very difficult, depending on four...
  • R
    Rivets reacted to ILENGINE's post in the thread When a battery is really DEAD with Like Like.
    And that is the downside of electrical issues. You can spend hours and hours tracking down and repairing what in some cases us a minor...
  • R
    Rivets replied to the thread Flywheel adapter 611032.
    You are correct, I attached the wrong manual. Service manual for that engine is Tecumseh part #740047 which I can’t find a PDF format.
  • R
    Rivets replied to the thread Flywheel adapter 611032.
    I looked at the parts breakdown again and I’m wrong. Your engine does use a flywheel adapter, not flywheel key. Trying to explain its...
  • R
    Rivets replied to the thread Flywheel adapter 611032.
    I’m thinking you need an offset key. Probably one of these...
  • R
    Rivets reacted to ILENGINE's post in the thread Briggs OHV on Troybuilt push mower with Like Like.
    Overfilled or mower being tipped in a direction that is allowing oil to enter the breather where it can flow into the air cleaner. Or...
  • R
    Section 8, starting on page 20 of this manual describes how to do it. Shouldn’t be very hard. https://www.toro.com/getpub/22446
  • R
    Rivets replied to the thread K301.
    Hammer makes a good point, battery or magneto? 301 came with both systems "
  • R
    Rivets replied to the thread K301.
    The first 10 pages give you a good overview on how the magneto ignition system works. I don’t know how much more I will need. The only...
  • R
    Rivets replied to the thread When a battery is really DEAD.
    Sounds like your charging system is not working. With engine running, at full speed, and no blade engagement, measure voltage across...
  • R
    Rivets replied to the thread 19hp Briggs carb float.
    We need model, type and code numbers. Should be stamped on one of the valve covers.
  • R
    Rivets replied to the thread K301.
    Please post engine spec number so we know which electrical setup you have. This manual may be of some help. Section 8. Im assuming...
  • R
    Rivets replied to the thread husqvarna z254f transmissions.
    If pulley bearings are bad the belt will not have the proper tension and will wear faster and jump off.
  • R
    Rivets replied to the thread husqvarna z254f transmissions.
    Sounds like rocks in pulley? Bad bearings.
Back
Top