Recent content by RevB

Cash leaves you no recourse. Customer says, mechanic says. I do all my own work so the card only gets me parts for which I can challenge quality. It's leverage against bull****tery.

Never pay cash, always card on service. Then you can dispute the hell out of it.

That's what I suspected poster meant. Files 😜

This damn forum software sucks....what damn site DOESN'T take jpeg files. And for mobile devices....halt, stop, freeze, tries to correct your spelling.......y'all should ***** hard at this site's owners.....but good luck finding them. Rant done. Get a set of grease needles off Amazon. In most...

"Torch tip" ? What the hell is that.

#1 - Pay with a credit card? Put it in dispute with your card company.....

One of the things I wish these muffler guys would do is cut some vertical bracing webbing welded between the flange and the muffler body. That's a hell of an overhang just sitting there bouncing up and down and vibrating cracks right into the muffler body and flange welds.

Reason I asked about the "struggle to start" issue is because most of the starters on small engines look like they're well sealed but are not. Because of the dusty, litter ridden environment material always seems to work it's way into the case and the dirt will cause the starter to slow down and...

New, defective parts. Good on ya for finding the problem.

When you say "struggled" are you referring to cranking or just once started, running.

Also, my 730 water cooled likes choke when cold and no choke when warm. Just depends on the degree of "warmness". Also had a problem with the original Kawasaki coil wires....they are carbon track "wires" meaning that there is a carbon impregnated string that forms the current carrying member of...

Gas in oil is highly unlikely. Your timing should be fixed but the coil to face is slightly variable. Make sure there is no rubbing of the flywheel against the coils. It'll still run but not the way the parts should be set up. Business card is a good approximation.

It's a 3/8" bolt...the head could be anything. The spec does not say 3/8" head.....

https://images.app.goo.gl/YvdpYACsbiEg123D6 General guidance......

These iron or aluminum cylinders?

Thank you! I'm yelling at the suggestion to "cut it off".....🤔🤫

Did you adequately space the coil faces from the flywheel or just eyeball it?

You dont want a mower for that. Something like a DR push string trimmer.