Recent content by Repsol1k

I’ve tried both of these bolts with no luck. Any other suggestions? Thinking I might have to pull the motor and have something new drilled and tapped.

This is amazing thank you!

Hey, the shaft was tapered and I had a machine shop turn the shaft into a keyed 1 inch diameter for the clutch plate 1980 Argo 8x8 off road vehicle Tried a 3/8x24 and it was to large

I’m doing a motor swap in an older Argo. Put in a Briggs and Stratton 20hp vanguard v-twin. 351447 1064 E1 The motor had a tapered shaft and was hooked up to a generator. I cannot find what end bolt size I need. I have tried 5/16-18 and 5/16-24 both don’t thread correctly. Tried an M8-1.25 and...