MParr's latest activity
-
MBBill, get your act together. There are two different numbers because you said you need both belts so MParr gave you numbers for each...
-
MMParr replied to the thread Big dog alpha. What size belt does it use?.Rotary is an aftermarket distributor. https://www.rotarycorp.com/search?q=11661 https://www.rotarycorp.com/product/14939
-
MMParr replied to the thread Big dog alpha. What size belt does it use?.Deck belt: Rotary #11661 Drive belt: Rotary #14939
-
MMParr replied to the thread Big dog alpha. What size belt does it use?.Hustler part # 607162 for deck belt. Hustler part # 607400 for dive belt Please verify.
-
MDo you have any ideas how many different types of units Big Dog has produced? Not going to get much help unless you post model and...
-
MMParr replied to the thread New carb revs too high.FWI: Before removing the carburetor, mark the throttle cable on both sides of the hold down clamp. By doing this, you will be close to...
-
MIs your basic throttle cable set correctly in the holder bracket? these have to be adjusted as well. Do not mess with the governor.
-
MMParr reacted to ILENGINE's post in the thread This is the stuff that makes small shops look bad with
Like.
Here is the correct plug for comparison Notice the thread length difference and the washer instead of the tapered seal -
MFor me, the worst offense is running your mower with the discharge chute held open, and directing the discharge toward the road. Usually...
-
MMParr reacted to mx842's post in the thread Has anyone ever adjusted the hand brake on a Gravely ZX HD 52 with Like.
I got back from vacation and called first thing Monday morning, but they are closed on Mondays. Called back Tuesday and at first they...
-
MHello, Tiger, Small Engine, I cannot recall ever replacing a rider engine flywheel key unless a DIY type forgot to tighten the center...
-
MMParr replied to the thread Tips for blade sharpening, how do ya’ll do it?.40 grit flapper wheel on an angle grinder.
-
MMParr reacted to SeniorCitizen's post in the thread Tips for blade sharpening, how do ya’ll do it? with Like.
I'll be getting a flap grinder for my Makita .
-
MMParr reacted to slomo's post in the thread Tips for blade sharpening, how do ya’ll do it? with Like.
Which never happens. Used motor oil slathered under the deck works like a charm. Great way to recycle.
-
MMParr reacted to Dixie Boosh Wookie's post in the thread Tips for blade sharpening, how do ya’ll do it? with Like.
Angle grinder. Hang it on a nail.