Mark H_NO's latest activity

Solenoid mounted to starter, or separate(remote), I believe.

Holy Cow! I got back to putting the tiller back together today. Forth pull and it sprung to life! I actually fixed something lol. I...

piston down 1/4

I think he was asking what should be 1/4" past, piston, or flywheel.

While it is possible to have a level cutter deck, the blade head/spindle angle should always be slightly lower at the front than the...

Sounds like the factory wiring diagram may not help a lot. While checking on wiring, it's always a good idea to clean up the battery...

Get out the voltmeter. Check those fuses, voltage at battery, battery connection at solenoid, wire from ignition to solenoid(key in...

I had the same problem last year with my Ariens Zoom 2148. After checking spindles, pulleys, idlers and everything else I could think...

I installed a carb for the correct spec number of the engine. Seems to have fixed the problem.

I just saw the fuse in Star Tech's diagram. Check the fuse, and the matching wire at the switch. See if you get 12v there with switch...

When you get it to crank, where are you connecting at the solenoid? Is it a big wire or a little one? If it's the little one, the...

It worked yesterday. It does sound just like something banging into sheet metal to me, which is why I said to check blades, though...

So, you say the key went dead. Is there no sound at all when you turn it to start? You say battery is good, how did you test? When is...

Rivets has a point, but I've had pretty good luck pulling the bowl, cleaning float needle and seat, blowing carb cleaner through the...

Do you have a voltmeter? Measure voltage engine off, then start, and measure again at full throttle. Measure voltage with blades...