Recent content by Lonestar

Yeah, I know what a Stillson wrench is, I couldn't understand where you were saying to put it. From what I can see with the clutch still in place, I'm not sure there is any accessible place to grab with it, but I will know as I remove the clutch. Maybe the spacers are a possibility. I've...

Not sure what you are saying??

I was wondering how to keep the rope from putting pressure on the valves. What does the helper need to do? Are you saying it's probably OK to use a screwdriver wedged in the flywheel? I wouldn't think 55 ft lbs would not be a lot of pressure on the teeth.

Got it, thank you. What is the preferred way to keep the drive shaft from turning while removing the hex cap screw and re-torquing? I've seen videos where sprk plug was pulled, and a piece of rope was inserted in the top of the cylinder, and then another where a screwdriver was used to wedge...

Or it's possible that the Clutch Stop Bracket can be removed and access to the drive pulley made that way by just slipping the belt over the clutch. I'm looking for the most simple way to do this and was hoping someone had actually been through this process. If I do have to drop the clutch, do...

Cub Cadet apparently made some changes in the XT2 in '21 as in using an electric clutch. I can't find any info online as to how to change the drive belt with these models. It looks like either the clutch has to be removed, or the bracket holding the clutch has to be removed in order to slip the...