Recent content by ken2

This is the little hose.

I don't need the tanks just the little rubber hose for both left and right side.

Just cleaning up my 2019 32" Time Cutter when I noticed this hose (circled in green) on both hydros is disintegrating. I looked it up on Toro's site and have to buy an expansion tank kit forboth sides to get the hose. The kit number for the left side is 121-5735 and it costs $89.09. Is there...

How many hours on the average will the hydros last on TORO 32" TimeCutter SS3225? No problems with mine. It's a 2019 with 240hrs.

Nope. I have the belt so I'm ready. My mower has 59.2 hrs. Hope it doesn't need a belt for a while. I already had to replace the hour meter. The BB looks easier than my TORO.

I wonder that myself. I have one of those old Briggs tach's that work off vibration. I'm going to compare the too when I get a chance.

There is not much to rebuilding a deck really no need for a kit. Get new idler pulleys. Take the spindles apart and get the number off the bearings. Any welding shop or auto parts store can order them. I buy bearings for my mower from "Weldon Eldon's" they cost $8.19 each.

I ordered a new meter for mine off ebay $59.99 free shipping. My old meter will light up if I remove it from the mower and shake it and play with it. I think it has a loose connection with the internal battery. Mine is a 2021 with 59.7 hours. Thought about buying a cheaper universal tach/hour...

The hour/tach on my 54" seems to be intermittent. On for a while and then off. It has only one wire and that goes to the spark plug for the tach.

100% normal for them to be packed full under the plastic cover. They need to be blown out with an air compressor once in a while. The engagement lever often gets bent so it won't engage completely.

Was putting all my mowers away for winter. I noticed the hour/tach meter on my 2021 Magnum was not working. It doesn't have any display on it. Is there something I should be checking wiring wise or does the meter need replaced? It had around 60 hrs. It was working last time I used it which was...

My 2021 54" doesn't have wash out ports.

It's common for the RERs to get packed full under the belt cover. Problem is worse when using a mulching blade. Only way to keep them half way clean is to blow them out with compressed air once in a while. The lever shouldn't hit the pedal. I'm wondering if the belt is stretched out too much or...

That weld was only holding in two small places. One at the very top and at the very bottom. The rest of the weld was doing nothing. Clean it up and have it welded again correctly and it will hold.

It looks like a 33". Take the blade off and measure it. For years Snapper put the tag below the battery. The acid took care of the tag. I think I still have a belt hanging on the wall for a 33".