Recent content by K_mase84

Ok so here is an update for everyone who has been helping me or following this. We have lift off. She runs good. After we determined the starter was no good i put the other one on and the flywheel starter spinning but no spark. So i swapped the coil for the other coil and boom ? fired right up...

And I know the starter would be good because the other tractor started right up before I broke the connecting rod

Based on the information you gave me the starter didn’t do anything at any time so can I take the starter off of the other motor and use it

OK so i taped the Ok so i taped it up and left the kill wire unhooked to the coil. I hooked up a battery and made sure there wasnt any voltage on that black wire to the coil. I tried to start it but it was making a clicking sound around where the starter solinoid is under the seat. so i...

I have this carburetor from the other tractor also

I also have this newer alternator i could swap out if that would be better.

So leave the plug empty? What about the ground loop that would normal screw into the block?

Yes you were right about SN had them typed wrong

So what would be the best thing to do. Put the Nikki carburetor on and hook the plug up to it and then terminate the ground on the blockOr leave the carburetor that’s there on there and just leave the wires unhooked

I have this harness minus the red little jumper wire

Yeah I worked for a golf cart manufacturer for about eight years and used to use them all the time we would stretch golf carts so I would have to make all new harnesses for you it’s a great thing and a tool where you need it I just I’m trying to get through one mower that’s my personal property lol

I’m familiar with Molex plugs end and crimpers but I’m not going to purchase this equipment to fix my lawnmower I don’t work on the stuff enough. See the attachment this is the harness that I have and it has a double pin plug one side is gray and one side is black and the black wire has a...

Thank you for your reply the harness that I have off of the poulan lawn tractor has a double pin plug that would plug into a carburetor solenoid so the motor that’s in the craftsman tractor that I’m trying to get going looks like it just has a two cycle carburetor on it there is no solenoid...

Hi everyone I have a craftsman LT1500 tractor that looks like someone put an older motor into. My friend gave it to me today and I need some wiring Help...The motor serial numbers are. 313701 0126-E1 020626ZE. So It is a Briggs motor just not the motor that came in the tractor. Im assuming it’s...