Recent content by Jag99

No, will that make a difference on pressure? AutoZone .

Bad compression. Only 70.

There isn't an arrestor on that model, just a muffler. I'll check the compression.

I have spark. Followed start up instructions. Plug is wet. I reset L(1.5 ) and H(1.0) turns fuel screws to factory spec for Simperac new carb I bought on Amazon. I then tried starting fluid down the carb throat and still couldn't get it to fire in either 1 or 2 choke position. I'm wondering...

Bought used not starting. Replaced carb, fuel lines and filter, spark plug. It is getting gas to spark plug. Pulled coil which was set on flywheel @ .10. Ohm tested coil 4k. Should there be ohms the between the shut off terminal on the coil and the spark plug? If I unplug the wire from...

No

This is a brand new carb which came with the float bowl. There is no way it would need to be rebuilt. Tecumseh 632671A

Craftsman self propeled 6.5 hp Eager 1 engine fails to run but a few seconds after starting. Origiinally I could get it to start after priming 20 times with priming bulb, but had to continuously push the primer to have the engine stay running. After 20-30 secomds the engine would then run for...