ILENGINE's latest activity

That basically confirms that the ignition module is heat failing. And would require the replacement of the ignition module

Ignition would be my first guess, but will need to confirm loss of spark after engine dies with a open gap spark tester, not a blink...

What is it actually doing to make you think it is loosing compression.

Need to get the model information from the transmission tag. The fan and pulley would be a tuff-torq part not Husqvarna

Engine has been replaced also. Only 38 inch deck made in 1994 or 1995 had a flat head 28m707 engine.

Get the model type and code from the Briggs engine. Sometimes those numbers can be used to narrow down and reference a few models that...

Banging clutch/brake pedal normally points to a chuck of the belt missing, and will change the tension on the belt as it goes around...

No air vane spring because there is no air vane. This engines uses a mechanical governor not air vane governor. And you won't see much...

Yes, I know the shaft can't be allowed to turn. I can handle that. I have two 13" rims from my trailer that will work nicely, I think...

I normally jack up the rear wheels and put blocks under them to hold the mower up to give clearance without the jack being in the way...

Or the mower because the battery was obsolete before the mower was even purchased.

Most likely it has broken compression rings or a badly worn cylinder allowing too much pressure back into the crankcase. A failed...

So I'm going to conclude that you are telling me I need to detach the whole hydraulic hose from the steering box so that it will turn to...

Snapper used about a half dozen different discs. Need model number to determine which one you need.

Thanks. I'll get model info tomorrow.