ILENGINE's latest activity

Hydrostat belt either came off or broke. Need to look up under the rear of the mower, above the deck belt

Deck drive belt should come off the left side of the center spindle pulley, go to the right of the flat pulley behind the center spindle...

If this is the setup I think it is Snapper has a very similar mower and the swivel fitting for the hydraulic hose going to the cylinder...

Agree, The word if true or not about filling housings is anedotal at this point. One source says to not fill a wheel bearing...

Not the greatest picture but may be able to blow it up and see how everything is sitting https://a.co/d/ePKyaFv

@GearHead36 I don't know if it was a proven fact or some word of mouth that spread about, with the original reason being trying to...

That was the concern with overpacking wheel bearings. The extra grease causes heat retention leading to premature bearing failure. You...

Need to double check that ohm reading. Because if that 1 ohm is accurate that clutch is pulling 12 amp. Resistance should be in the...

Green wire on Kohler engines normally goes to the oil pressure switch either next to the oil filter or on some Command engines the oil...

Look at it this way. Most of the box store riders have 18-9.50-8 rear wheels. So the axle is basically sitting 9 inches above the...

I don't use the red pancake filters. Not fine enough filtering to prevent debris from not sticking the float valve open. I start with...

Correct. a 1/16" wear over several contact points can quickly add up to 1/2". And you know as well as myself, that over time a lot of...

@RevB I am confused on what you are trying to do. Using drafts deletes the auto saved text, but doesn't empty the reply box. When...

Not without replacing everything below the steering wheel. Now let me explain. Being 21 years old every rolling point, every pivot...

Looks like possible 1 screw maybe 2 Tecumseh has a habit of requiring the tank to be twisted away from the blower housing and then...