ILENGINE's latest activity

We are talking about the cost difference of a few bucks a tube of regular cheap grease versus better quality red and tacky grease. I...

I have seen several cases of grease failure over the years. A couple of those cases was Valvoline synthetic wheel bearing grease. Your...

Looks like the standard 5/9 Briggs voltage regulator used on single cylinder Intek from 10-21 hp engines.

You are looking at it like since the Lucas didn't move it isn't providing lubrication. I see it as the Supertech is no longer lubing...

And with an attitude like that none of the major techs on here will answer you. Bye, good luck getting advice.

Here is Project Farms comparison between Supertech and Lucas Red n Tacky Just got 3 cases of Lucas Red n Tacky delivered today.

Lets start with the actually model of Radius E series mower you have so we don't have to guess which of the something like 20 different...

The spring pulls the slide one direction the belt against the idler pulley moves it the opposite direction. And the idler pulley slide...

Allows small changes to the idle fuel mixture, but won't smooth out more major problems with running

I would say you are missing the spring that goes from the front of the idler pulley bracket with the U and the U that is in the deck...

The real problem here is that most DIY guys really don’t know how a small engine works, especially carbs. They think that it takes too...

I see this issue on a daily basis and read about it on the forums. "My engine surges up and down".... So, you are standing there...

Open the tester gap to 0.25" or 1/4" wide minimum. Should jump this gap if the coil is good. No spark with kill wire disconnected...

It looks like you have confirmed that the original module is bad, and sounds like the new replacement module may also be bad. And most...

Either have to lap the new valves into the seats or have a seat cutter set like the neway. I have the Neway seat cutter and valve face...