ILENGINE's latest activity

I don’t even know of a machinist in our area that will grind valves. When you factor in your time back and forth, and paying labor cost...

Something is goofy. The parts diagram shows a 3 way valve but the service manual shows a 2 way valve with the on-off lable for the...

Carb needs a thorough cleaning or a little more technical explanation. A carb has two fuel circuits. The idle circuit and the high...

According to Briggs the molded fuel line is 791766. The carb should be a 591925 but references a part requirement that isn't used on...

You are in the early stages of a blown head gasket. Blown head gasket between the cylinder wall and the push rod cavity is the second...

Can you provide the manufacturer label information of this yard machine along with the engine information stamped into the top of the...

Order a carb kit and accelerator pump kit for a Rehlko Command CV730 last week and just got around today to pulling the carb. and found...

Lets start with the model number information from the engine. So we can see which of the carb styles you have. Some systems were...

I haven't seen any crack from people trying to use the paper gaskets, but I have seen them warped at the mounting flanges so bad that...

It isn't so much as a preference to what you use. It is what the manufacturer recommends. The old Peerless gear transaxles used...

If the existing O rings are in good shape then reinstall them. Don't remove and use the other gaskets or try to put the gaskets over...

All of the single cylinder engines used on Generac products are rebranded engines. The V-twin is the only Generac built engine.

Your description sounds like a badly worn Deck PTO switch. https://www.partstree.com/parts/snapper-1738982yp/

The disc should unscrew from the shaft collar. The shaft collar is held on by if I remember correctly 2 set screws, and then should...

Here is the correct plug for comparison Notice the thread length difference and the washer instead of the tapered seal