ILENGINE's latest activity

Artificial intelligence gives answers based on what a person has fed the program with information. Artificial intelligence is already...

It will be find to run the deck without blades, But I would start by making sure the motor mount bolts are tight. only takes 1/8 turn...

A 46" mowing deck will have an overall width closer to 50" even with the discharge chute tucked out of the way.

Soft ratcheting feel to me would mean flat spotted bearings. And it would be easier and cheaper in the long run to replace it while you...

I just bought a new XT1-LT46 myself and haven't yet reached the 5 hour mark for oil and filter change. I didn't notice the Kawasaki...

954-05022A. just correcting the mistyped number in your post

The video shows the top of the tranny through the frame. I want to see the area on the side of the transmission from under the mower...

Item #1 in this picture is the service plug using the pump and fitting in this kit to refill the units

The problem isn't the carb the problem is the absolutely junk fuel. Since Briggs came out with this engine in 2015 the biggest issue...

The date code 11042862 uses the 796608 since you are before 11070100

Make sure the bowl vent isn't clogged. If the atmosperic vent for the bowl is clogged will cause siphoning.

According to Briggs dealer distribution the 796608 is still the valid number without being superceded. And the 591137 is also a valid...

That is a hydrostat with foot control. Husqvarna, SBD, JD all have that setup available. Just need to look around.

Have you checked to make sure there isn't gas in the float making it sink and not stop fuel flow at the float needle. Floats on...

I am surprised that this hasn't been noticed before. This isn't exactly a new mower. I think there was a 3rd party involved...