ILENGINE's latest activity

Actually the small wire ring is suppose to slip over the fuel line install the fuel filter and then slip the wire ring down over the...

The starter will turn backwards and keep the bendix in the down position if the battery connectors are reversed. negative to positive...

That is how they are supposed to work. The idea is to allow tank venting to remove the vacuum created by fuel leaving the tank, to...

I wonder who had the bright idea to make the oil pressure warning light on the dash blink when it corresponds with the CHG OIL display...

The rollover check valve is a 2 way valve and is only supposed to stop venting when turned upside down. So the non venting fuel cap...

I agree. It sounds like the rollover vent valve is not working because if this mower has the vapor recovery line connected to the air...

Got the Amazon carb installed, which is not my desired choice, due to quality control in most cases, but anyway the new carb allowed...

Little behind the times. SBD purchased the other 20% in 2023.

And the MTD name is now being replace with SBD outdoor. Stanley Black and Decker Outdoor.

4.10/3.50x5 is approximately 11 inch in diameter. So maybe narrower than the spec'ed tire but same height.

Front 11x4-5 4 ply rear 18x9.5-8 4 ply

Husqvarna

Screws might have come loose and the throttle plate is wedged in the carb.

Small limbs can cause the chain to ride up out of the top chain rail also any sideloading of the bar can cause flexing to the point of...

Things to looks at would be the steering sector gear, and bushings. The wheel spindles, the tie rods, The front axle and bushings, and...