hlw49's latest activity

Try turning the ignition on and off. Some you have to cycle the ign on and off and some the pump runs until it builds pressure.

yes

Made a puller to pull them out on Briggs and Kohler carbs with brass seats Kohlers new seats are Zinc and alcohol fuel won't damage them.

I take shop air and stick it in the fuel line fitting of the carb and blow it out. Tool works great to install it.

YW glad to help

Could be the PTO switch. Start circuit goes through the PTO switch.

YW

You can use toothpaste not the jell the white paste type and a Q tip.

looks like it, keep it greased, and it should last a long time

https://www.dixiechopper.com/wp-content/uploads/2020/05/2011-magnum-iron-eagle-parts-manual.pdf

https://shop.dixiechopper.com/viewmachine?catalogId=1767&assemblyNumber=undefined&mediaId=10362

Check the switches on the steering levers and not just the switches the terminals make sure the wires are connected good.

Have a friend that has a Tanaka TBC340 awesome Trimmer as I own one. He was complaining about no power. I told him to check the exhaust...

Check the kill wire where it goes into the kill terminal to make sure it is opening enough not cause this problem.

Holding the key when it is hard to turn over can burn the starter up. Adjust the valves and try again.