Recent content by GovtMule66

Has anyone on this forum ever purchased a new K46 transmisson directly from Tuff Torq? Will Tuff Torq sell complete transmissons to the general public or do we have to go through a supplier of theirs? My Dad owns a 2010 model John Deere D170 which has been garage kept since he purchased it...

I finally figured out why I could not lower the Height Adjustment Lever down below the 2 1/2 mark on my John Deere D170. At sometime in the past the MOWER DECK LINKAGE SHAFT (GY20608) had been knocked out of alignment which would not allow the Linkage Arm to pass the frame on the way down. I...

I am having problems with my John Deere D170 height adjustment lever. When I try lowering the cutting height adjustment lever the lowest I can go is 2 1/2 even with the mowing deck off the mower. Should I not be able to move the selector handle between 1 & 4 with no problems? Whether the...

Thank you once again and yes the part I received incorrectly is just like the one in you're photo. I don't know how this vendor is getting by selling both of these carbs under the same part number but I will send it back tomorrow.

Both of these Zama Carburetors have the same part # on Ebay....Zama C1M-S260B Carb 4241 120 0615 In one of the below photos I have a arrow pointed toward a tube on the primer body. I was wondering if someone can please tell me what the purpose of this tube is? Thanks in advance

Good Afternoon Everyone. Recently my Dad purchased a 2nd hand 2002 Troy-Bilt Riding Mower (Model #13CX609G063) as a backup mower for our small farm. The mower he purchased had been left setting outside for several years until my Dad rescued it and now my Dad and I have worked this winter...