Recent content by geoweaser

Thank you for your feedback. I'll get the connections cleaned and apply some contact grease.

I think I diagnosed the problem. It's related to a fickle connection with the ignition switch and is described in this post: https://www.lawnmowerforum.com/threads/airens-zoom-max-stalls-wont-restart.70464/#post-438646.

I've done some additional testing and now think I may have been facing at least two problems simultaneously. First, I replaced the fuel filter. The old one looked like it'd been around a while. To start the mower for additional testing (described a bit below), I used the choke for the initial...

Sorry for the silly question: I assume I put +12 V on the purple wire. Where on the moder do I connect the negative side of the voltage source?

Thanks for your reply. I will try to find a replacement fuel filter to rule that out and will conduct the 12 V test as soon as I'm able. The engine does not surge at all when it stalls out.

I have an Airens Zoom Max 60 with a 25 Hp Kohler engine. Yesterday, it started fine, but cut out after 15 minutes or so of use. No strange noises. It started right back up and ran for a couple of minutes before cutting out again. I don't remember how many times this happened, but after a...

Thank you. Yes, by "turn over" I mean it won't start; nothing moves and not even a sound is made. I checked the battery, which was fully charged, and a couple of fuses I could identify, which were also good. A bad ground or a problem with the power supply are possibilities. there a good way to...

I bought a used Airens Max Zoom 60 ZTR with a relatively new Kohler CouragePro 25, had it repaired including a carburetor rebuild, and have run it for probably 10-15 hours. It just quit after about 15 min. of running. I tried to restart several times up to a four hours after it quit with the...