Forest#2's latest activity
-
FForest#2 replied to the thread Stuck tire.On some similar rims that are rusted to the axle I've taken a very large threaded nut and welded to the rim and use a large bolt...
-
FForest#2 replied to the thread Stuck tire.After the plastic pipe is warmed and pressed onto the rim I use shoe goo to seal the pipe to the rim and then install a 90 degree...
-
FForest#2 replied to the thread Seat kill switch problem?.Set down in the seat and test if you are still standing up. But disable the PTO, apply brake, and don't breath. Might still be under...
-
FPut a break over bar with socket on flywheel nut.
-
FIs why use a low pressure setup. The HF one only uses 15 psi to get to the full scale set mark. With it I can hold the flywheel with one...
-
FForest#2 reacted to hlw49's post in the thread Briggs engine on Toro recycler mower is possessed with
Like.
Check the kill wire where it goes into the kill terminal to make sure it is opening enough not cause this problem. -
FForest#2 replied to the thread Briggs and Stratton Warped PLASTIC Intake Manifolfd.Amen
-
FForest#2 reacted to davbell22602's post in the thread Briggs and Stratton Warped PLASTIC Intake Manifolfd with Like.
I agree. Bring back the Briggs Lhead twin engines.
-
FForest#2 replied to the thread Blowing oil out of breather.The things you were inspecting is one good reason to do a LEAK DOWN TEST FIRST. You will reach for your new leak down tester quite often...
-
FForest#2 replied to the thread Tiger Cat gas cap tether fell into tank.Can you see it?
-
FForest#2 replied to the thread Repeat of Compression Relief Failure Causing Choke-Sputter-Die, or Both?.You asked? is this the compression relief system again? From your description, not likely yet. Did I overlook the engine model, type...
-
FI agree with the feedback above. I believe if you want it to just run and smoke it’s time to order a $10 carb and see what happens. I...
-
FForest#2 replied to the thread Blowing oil out of breather.It appears this would be a good engine to get familiar with your leak down tester. Not likely but A bad breather valve can cause such...
-
FIf the HFT one is like the one I got from them it is a low pressure type that makes testing lower cylinder condition on OHV engines...
-
FForest#2 replied to the thread Blowing oil out of breather.In post #3 StarTech said to do a leak down test. Very good suggestion. Search for info on-line about doing a leak down test and the...