filmteknik's latest activity

That would be interesting, not to cover the opening (I'd still use metal) but as a sealant instead of RTV. But I did a quick search of...

Phil Swift has several products that might be useable by you on that poor old Tecumseh. Check out the race car he put back together at...

I defer to your experience but you are misunderstanding about the patch. It is not there to add any structural strength but to keep the...

I have disassembled the engine after all and it seems fine. Aside from the overspeed and self destruct #2 it ran well. What money...

I'm glad you are enjoying because I am enjoying it myself. That's the point. If I wasn't I would take it to the curb for the...

WTF is "ethnic engineered"? Gasket where? They don't make gaskets for holes punched in the side of crank cases by broken rods. But...

Following up. I proposed to get a used rod and was asking about attaching it to the crankshaft thru the hole the mishap punched into...

Yes, very used. Surely not a current model. Thats why I said I was clearing a few issues. I believe it is 12 years old.

As said it is probably gear meshing is incorrect. Check all bushings and sleeves on the drive axle and the bushing and retaining bolt...

The gear in the wheel is showing signs of wear and tooth tip curling. So the drive gear and the sprocket may be getting an offset...

Seriously, I'm asking not telling. I bought a Toro 20334 recently and I'm clearing a few issues. One of which was Personal Pace was...

Over my head would be full dismantling. Doing it the way I propose - if it can be done - is about the level my head is at! I bought a...

I did buy a used Toro with a Briggs; how good it is remains to be seen. This is just a project for fun. I guess there is no way to...

Not sure what to tell you since you clearly are not replying to the question I asked.

I grew up with a series of Sears mowers with Tecumseh and then two Lawn Boys. I'm old enough to remember the 2 stroke cycle LBs. We...