Recent content by David2291

Bad ignition switch. Jumped power to the yellow wire off of it and everything worked. Replaced it and runs fine now. Thank you to everyone who helped

Sorry replied to the post not yours. Not sure how notifications works

As the relay goes I have found one that’s bolted under the solenoid and replaced that but nothing. Unless there is another hidden somewhere i don’t see

So after thinking about the daisy chain between the ignition switch, pto and hour meter I checked voltage between the switch and the pto switch. I’m only getting about 5 to 6 volts and then nothing past the pto switch. So I checked continuity on the ignition switch and the ground to magneto have...

I did replace the solenoid and it’s cranking over fine just won’t run once I take the brake off. Now if I unhook the relay it runs but no pto. I’ve seen two ground wires that are bolted to the same as the negative that are rough looking but not terrible. I’ve seen the wires that link the...

Was this ever solved?

I checked the three fuses and all are intact. Unless there is a fusible link somewhere

I have a 2009 Z225 went to start up a week ago and nothing. Replaced battery and the solenoid and ended up shaving the fuel solenoid down so it wouldn’t be up and started up. How ever after replacing the fuel solenoid the plunger won’t move from the off position. Also when disengaging the brake...