Recent content by BKBrown

I'm still looking for a Sickle Bar for the Ventrac and understand that Steiner had one at one time that would fit. Does anyone have any recommendations or know where I could get one ? Thanks !

For some reason - it wants more length to message ?

I have the grader blade and the excavator bucket, but the blower works great for anything deep ! v bar chains on all 4 makes this go in nearly anything !

Looks like plastic items you could use a pick up tool similar to this to get them out ! I rotated and cleaned up your picture some.

I'd love to have a Sickle Bar mower that will fit the 4231 - It would need to be 6' to 8' to reach close to the pond on the inside of my Dam. I don't want to spend a small fortune and don't (won't) do ebay or paypal. Is there anything available for the Ventrac - even if it needs to be self...

Get a pick up tool - many versions available fairly cheap - reach in and grab the item without removing tank. Auto parts store should have the tool.

Pickup Wizard For Small Fruits and Nuts (3/4-inch diameter minimum) | A.M. Leonard, Inc. Have not used one, but just came across this in a catalog this weekend ???

The blower is serious - we had two 2' snows and the blower had no problem doing 9 LONG drives and over 1/4 mile to the main road.:thumbsup:

I had no problems with the fenders and on the first 4231 (I had an 04 and now have the 2011) the rear frame was a bit close - the new 4231 has more space between the frame and the tire. I use chain tighteners so there is no space between the tire and chain. attachmentid=7036&stc=1&d=1340809934

Oregon also makes what they call an "Exmark Mulching Blade" that has an upper and lower cutting edge on each blade. They work well, but (I found out the hard way :eek:) they will bend if you hit anything and I have not found out a way to get them bent back straight again. They do come in...

Just FYI There are 2 options on the Ventrac for bush hoging - Their Tough Cut mower deck and I have used the Meg-Mo blades on the finish cut mower deck - they do a great job and the knives kick back like bush hog blades if you hit anything. :thumbsup: These are the Meg-Mo blades on the...

Can't resist --- On the Ventrac - the mower is out front - lift cover off - pull 2 pins - flip deck up - put in pin to hold it up - remove blades with 3/4" wrench -- sharpen or change -- reverse process --- Easy ! I LOVE my Ventrac ! :thumbsup: :biggrin:

We have a pond and this is the back side of the dam - at the steepest it is about 37 to 38 degree slope (most 30 or so) the 1st pic shows slope meter. This is facing uphill with the dual wheel set on the Ventrac. I can do it with the Ventrac and duals - I would not attempt it with a lawn or...

stock 8 Hp Briggs from 800 Special

71 800 Special manuals