Recent content by biggertv

From gas tank to Electric Pump to Fuel Inlet. Didn't cap Anything. No, gass does not flow to the pulse port. Apparently, design of the pump won't allow flow there. Oh and I used the Headlight Wires. To all the Purist out there: I used Wire Nuts on Power Lawn Equipment. I did Not measure Voltage...

It will piss you off how Soft they are. I once installed a Roll Pin in place of a worn out keyway...Thru the Flywheel. Cheap Harbor Freight drill bit went through that Crank like Butter. For the Oil Passage, simply dremel a small area enough to drill the correct angle. With Oil in the passage it...

Install New Blades. Unbalanced Blades will Very Quickly destroy the Spindle/Mandrel Bearings. It's not like an unbalanced fan blade...Mower Blades are Heavy. Bye Bye Bearings. You'll have a much smother and quieter mowing experience too. I recommend XHT Blades if you can cross to your blade...

I recommend crossing to a set of XHT Blades. I don't buy blades nearly as often as I used to, these are stronger than stock and last a long time. Hardened Steel.