Recent content by bartles

🤣🤣🤣🤣, Wow!

Sorry, I am technically challenged. If I can figure out how to compress the photo of what I am talking about to get it to you. It's a flat piece of metal, about 1/2" wide x 3-4" long. one end is bent 90degrees about 1/2". There is a slot in the bent section. bartles

Thank you!

What is the year built of a : PA-SV735-3021 s/n 4217706133 ? Thanks in advance, bartles

Sorry for not finishing this story. I got the engine running and confirmed both the drive units are in good shape. The keyways on both units are a little worn but the mower runs good. I decided not to restore the mower...the deck is not in good shape, and the electric clutch bearings all need...

Ok, I've rebuilt dozens of small engine starters. I bought a "Far Eastern" starter and this was packed with the terminal nuts...what is it for?

The I.D., axle dia. is 1/2" The bearing O.D. is 1 1/8", and the width of the bearing is 5/16" The flange diameter is 1 1/4" Thanks a bunch! bartles

I can't get past 5am...aging process!😁

I'll take them out and let you know...thanks again!

Thanks!!! You are up early for a Saturday morning!:LOL: bartles

I can't locate what the valve lash clearances should be for a Honda engine, GCV160LA0 S3B NH1. Hope someone out there will have those! Thanks in advance, bartles

Working on a Model HU700H, 961450024 01 I need to replace the rear wheel flange bearings as well as the drive pinion bearing in Part No. 585281901(adjuster). The bearings are not listed as an available part in Husqvarna's website. Thanks in advance, bartles