Auto Doc's's latest activity

Hello P., I help folks in my area with generator issues and sizing quite often. It amazes me how many people do not understand...

Hi CG, That looks like a match in pictures and on Parts Tree. Winner!

Hi MParr, That deck uses a wide front roller in the middle instead of the single wheel. It does look very close though.

https://mowerpartsland.com/product/bolens-lawn-mower-11a-414a065-carburetor/?msclkid=ca6703bbc52610fb5c936b45e49efc61

Hello B., Unless the carburetor is badly damaged due to water in the fuel, I suggest a full rebuild or get a replacement carburetor...

Aluminum will still oxidize back to a duller finish.

Hello H., Most Husqvarna decks are gray for the ones I have dealt with. I have seen a rare few early Scotts brand mower decks that...

Hell D., These are known as a Belleville spring washer. Cup towards the pulley, raised center so the nut or bolt can tighten against...

Hello L., We've all been there before and will catch ourselves going there again. LOL

As the saying goes... they say, "it fits", but that does not mean it works.

Hello P., This is only a 10,500-Watt steady power unit. That is too small to run a whole house in my opinion. People often pick too...

Hello P., What are you planning to do with the generator? If it is for emergency standby? Anything below 12KW running watts is a waste...

I'm guessing it's from an 80's Simplicity or Ariens because of the 3 front wheels and the greaseable spindles.

Hi P., Please don't mix subjects. Open a separate thread post to discuss portable generator choices.

Those long screws (studs) that hold the carburetor on have a star on the tip that require an E-torx bit to take out. The studs each have...