Auto Doc's's latest activity

Take it back to Home Depot and have them do a one for one exchange, or they contend with a local dealer to get warranty addressed. You...

Hello ACF, Check on Ebay for a "small engine cylinder hone". (They are very affordable) They have 3- stones usually. You need a fine...

Hello sano888, Most likely, the starter Bendix gear has split in half or sheared the teeth off of it. I recently repaired Kohler 22 HP...

Hello Just Don: Craftsman sold a couple of different designs. A couple of pictures would help us to help you sort this out.

If you are going to switch back later, I would leave them in place.

As I recall the JD L100 was only built for a few short years for the big box stores and discontinued due to low sales and chronic...

The issue may be with the generator section and not the engine.

Sounds like the throttle cable jacket is not properly locked into the handle retainers.

Hi StarTech, They should all work under 20 psi if the regulator is lowered down to 0 psi and pressure gradually adjusted up once it is...

I have genuine 1-1/8 V-belt drive pulley from Craftsman rider if you are interested. It has the crank key made into it.

Does the tensioner pulley spin freely without growling noise? Is the tensioner arm moving freely and no wobble? Is the tension spring...

Chain link fence piping is usually thin wall construction and galvanized, any kind of welding will be a challenge.

So what happened was we were cruising just fine after the fixes I put in months ago, but then a couple of days ago a bot hit us (and...

Hello Mac29, Let us know what you need help with. Make sure to always provide your machine product serial number label and engine...

Hello Mike, Place 2X4's on each side under the outer edge of the deck housing, then lower the deck so it can rest on them Where the...