Auto Doc's's latest activity

Hi ACF, Yep, I read that. 12V going to it does not mean it is working physically. I've had many that even "click" but would not open...

Hello the.doc, As ILENGINE mentioned, the head gasket is giving out on the pushrod side of the head. The head would need to be removed...

I have had to use air gap type spark testers on a few to get them up to max (SE) KV and prove it to the disbelieving customer several...

The replacement spindles typically have sealed bearing installed. The spindles need to be taken apart and the inner bearing seals...

Surging at low speed is most common with a possible air leak at the intake mounting gaskets, or the air bleed circuit machined into the...

The new carburetor could be the issue if it was from Amazon. It is likely not jetted correctly. Do not mess with the governor. The...

First, always use distilled water. It works really well by itself in an ultrasonic tank. Just for good measure though I add a splash...

Please provide the engine model and type numbers stamped into the valve cover (B&S) or on the label if it is a Kohler engine. The...

What part are you having trouble with, reference the diagrams...

Hello Mattmotors, This carburetor design was used on many different applications, so the parts like the choke lever would be different...

Check the fuel shutoff solenoid at the bottom of the fuel bowl. The pintle is likely stuck or the solenoid has failed. Water is not kind...

Hello hek2000, Welcome to the forum. We need the product label information so we can look up what you are working on. Snapper made...

This favors blades out of balance or very worn spindle bearings. The tensioner idler will jump back and forth, that is normal. As for a...

Don't expect the puller to be in the Briggs and Stratton manual, they did not build the mower, just the basic engine. The manual that...

We need the stamped number information off of the valve cover. There were different intakes used on many models. Model and type number...