Auto Doc's's latest activity

Rotary is a supplier.

I would suspect the coil, especially if the problem gets worse with heating up. The plug may be questionable if it was purchased online...

Sounds like the tank is not venting properly. On older mowers they vented through the fill cap. On newer mowers they have a one-way...

Service manual says to turn crank shaft so rod journal is at 9 o'clock.

Have you inspected for damage from where it got stuck and then pulled out? Something got bent from what you are describing.

I think this is going to lead you back to a servicing dealer on this one. I searched several sites and parts are elusive through most...

Hi Tommy, Without the compression release operating properly the engine compression is too high for the starter to effectively crank...

This may help...

If it has a single wire from the stator, it is not dual charging...

I think you need to replace the primer bulb so it will not suck in excess air that will affect the carburetor's ability to pull in the...

Hi Andy, I remember those early "easy spin cams" but I also recall they sacrificed engine torque for easier starting. From the sound...

I'll be curious to see what happens. Thanks.

Use Facebook Marketplace or Ebay. Ask $250.00 or best offer. You'll get better exposure than just a yard sale.

What led to the original starter being replaced? Locate the back of the starter switch and pull the connector and reconnect it a couple...

Governor lever is on the engine, and the throttle lever is on the carburetor. You are mixing up the component terminology.