Auto Doc's's latest activity

Is there some magic formula for attaching JPEG photos from my SD card? I tried to yesterday and it kept telling me the JPEG files were...

You say "shredding" Is it physically getting chewed on by a pulley or a guard that is out of place, or is it just chunking section out...

https://www.partstree.com/models/287707-0224-01-briggs-stratton-vertical-engine/carburetor-overhaul-kits-1/

This is all adding up to a failed compression release. Aftermarket cams are junk and genuine Briggs are on backorder the last time I had...

Hello OldNoob, Nice machine that looks well cared for. All metal construction. 1990 10HP engine. This is about as basic "old school"...

Hello Tim4, Help us help you. Cub Cadet makes thousands of different models. Are we supposed to make a wild guess? When you post a...

Hi Scrubcadet10, Thanks for the follow up. I recall that site some years ago and thought it vanished like so many others with actual...

Wow! Rivets, that is an old manual selection way back when cast iron engines were king. I dealt with quite a few of those tired old...

Terrel Fixes All? Chickanic? James Condon generator repair and small engine? Ken's small engine? Or Dony Boy small engine repair...

On each side near the front of the engine, at the mounting plate area, there should be a plastic standpipe with a black dome vent cap...

Hello SC, I even use 1" wide mechanics sanding cloth if needed on the posts and ring terminal ends. Yep, clean and shiny means proper...

I've learned this over many years of bearings being installed by people assuming everything was properly packed with grease. When I was...

Unhook the throttle cable and move it by hand to see if it will pull it down to idle.

Make sure you pack the bearings by hand to get plenty of grease into the inner race of the bearings. A majority of bearings fail due to...

Most manufactured parts come from sources all over the world. Primarily where labor is cheap and unions do not exist. Both good and bad...