Auto Doc's's latest activity

While you are this far, grease every fitting you can find with a couple of pumps from a grease gun. Let us know how your belt situation...

Welcome to the forum. We have quite a few knowledgeable folks on the site that help you most anything lawn equipment related. 43151...

I had this exact problem on m RZT-50S. You have to remove the pedals the unbolt the cover plate at the base of the column. Once the...

It is slightly unusual for the "V" side of a belt to ride on a flat idler pulley. But that may be to compensate for deck cutting height...

Just for clarification, the problem is with the upper belt or the lower belt? Do any of the spindle look tilted out of place from...

Shoot me an email: aghunt83041@outlook.com and I will reply with a couple of pictures attached.

This has the belt on the deck and also one the comes from the engine PTO to drive the deck? I have a Z-Force 48 that is setup that exact...

You missed the point that the rod/crank journal bearing overheating is the cause for the rod bolts loosening. The loose bolts are not...

Oregen brand has been a trusted name for many years, and their replacement belts are usually an exact fit "Lifetime warranty" means...

Yep, hardware store 3-piece small brush set. They come with 1 each: nylon, brass, and stainless-steel bristles. I buy a couple of set...

Hello Mattmotors, Somehow this thread went off down the "rabbit trail". Have you found an engine yet

I'm baffled, why do you want to perform a multiple flush such a small amount of fluid? Seems to me that and empty with a lengthy drain...

I think these are sealed light grease filled gear boxes, not hydrostatic. There is fluid check that I am aware of.

Hello Mjhover, Sounds like a plan. Make sure you have a way to transport it in the future if needed. Pickup and delivery are never...

Usually, you have to remove the mowing deck and then raise the front of the machine to crawl under and study the linkage operations to...