Auto Doc's's latest activity

On each side near the front of the engine, at the mounting plate area, there should be a plastic standpipe with a black dome vent cap...

Hello SC, I even use 1" wide mechanics sanding cloth if needed on the posts and ring terminal ends. Yep, clean and shiny means proper...

I've learned this over many years of bearings being installed by people assuming everything was properly packed with grease. When I was...

Unhook the throttle cable and move it by hand to see if it will pull it down to idle.

Make sure you pack the bearings by hand to get plenty of grease into the inner race of the bearings. A majority of bearings fail due to...

Most manufactured parts come from sources all over the world. Primarily where labor is cheap and unions do not exist. Both good and bad...

While you are this far, grease every fitting you can find with a couple of pumps from a grease gun. Let us know how your belt situation...

Welcome to the forum. We have quite a few knowledgeable folks on the site that help you most anything lawn equipment related. 43151...

I had this exact problem on m RZT-50S. You have to remove the pedals the unbolt the cover plate at the base of the column. Once the...

It is slightly unusual for the "V" side of a belt to ride on a flat idler pulley. But that may be to compensate for deck cutting height...

Just for clarification, the problem is with the upper belt or the lower belt? Do any of the spindle look tilted out of place from...

Shoot me an email: aghunt83041@outlook.com and I will reply with a couple of pictures attached.

This has the belt on the deck and also one the comes from the engine PTO to drive the deck? I have a Z-Force 48 that is setup that exact...

You missed the point that the rod/crank journal bearing overheating is the cause for the rod bolts loosening. The loose bolts are not...

Oregen brand has been a trusted name for many years, and their replacement belts are usually an exact fit "Lifetime warranty" means...