Repairs almost new troy built 2 cycle trimmer and a 2 cycle blower

M

moose02

Member
was given and almost new 2 cycle trimmer, edger and a 2 cycle blower. Can not get them to run using 40-1 mix. old owner not sure but says he may have used plain gas. what do I look for
 
moose02 said:
If so hone and rings or just toss them
Click to expand...

If they were straight gassed, you can get a top end kit for them............ I do that often on Husqvarna saws and weedeaters......

Anything of good quality is worth a top end kit.......

In your case they were free, so it's worth it to you........ Did you check the pistons yet ??
 
.08 ounce for a quart of gas = 40 to 1.........I use non etho gas it lasts longer.........

I use one of those liquid measuring tiny cups at wally world for a buck.....
 
Jake8131 said:
You can buy the right oil at Wally World in a 3.2oz bottle and add it to 1 gallon of premium gas. Never use gas with ethanol in it. Screws the carb really bad after a while.
Click to expand...

Yes you can buy it in the 1 can per gallon of gas at wally world when it's in season... I looked for some 2 weeks ago and it's not there..... I buy premix by the quart when they have it on sale for 3 bux....... I save that for my use though.....

I recommend the Poulan synthetic oil 40 to 1, I did some checking and it's the same as the stihl and top brand oils.......also cheaper .97 cents for a 1 gallon mix can.........
 
Might be something else? Take out the sparkplug, put it on a metal piece on the motor with the wire plugged in, pull the rope and look for a blue spark at the tip. Not all that unusual these days for the ignition to take a dump. And check for a wet looking sparkplug first off, could be flooded with too much gas. If it all looks good I usually give it a shot of starting fluid in the spark plug hole, replace plug, try to start.
 
A compression test should give a good idea the health of the engine.

If it's low, probably not worth fixing.

If low, you can tear it down, check cylinder for wear/damage, piston ring end gap, carbon build up, etc.
If not damaged, just worn, a piston ring may fix it for you...
 
You must log in or register to reply here.
Back
Top