Latest activity

Just purchased a toro timecutter, it runs but not great. After running for a bit or engage the blades seems to sputter out and...

Looks like this may be the answer to my own question. I'll have to take a closer look next time I'm near the machine...

I have a craftsman mower with a Honda GVC190 motor. Anyone know where they hide the motor model number on these things? Its about 15...

New user here, so please forgive me if I mess something up. I have a corded electric lawn mower, which appears to be a Black & Decker...

when i remove the needle valve and spring for cleaning and then reinstall, it doesnt work right. what iam i doing wrong

Bought used not starting. Replaced carb, fuel lines and filter, spark plug. It is getting gas to spark plug. Pulled coil which was set...

Right about rubber cement no good for such. I've almost had to use a boot few times on good lawn tractor tires that got stobbed.. (but...

I'm definitely going to try that second type, I've never had good luck with the first either. It breaks, and now you've got a really...

Fuel lines to the primer, make sure they're not overly hard, make sure the bulb can draw and push fuel. There could be a clog.

Keep a heads up when around that type machine when off the machine with it running. It's the type that the blades will start turning...

I replaced the primer bulb. Other things to check to possibly solve this?

we have a 20055 that I just overhauled. It was taking 12 primes and two pulls to start cold. Had good compression, etc., just had 20...

Looks like the front of the deck is too low. engage the blades and check the pitch on the blades font to rear. needs about 1/8 to1/4...

engine noises like a piston or rod seizing typically are thunking or knocking. A squeal is high pitched and would not get out of the...

did you soak the area in Liquid Wrench or PB Blaster, Knock er Loose, etc., for 24 hours first?