Latest activity

I've replaced the damaged anti-rotate bracket and new transmission and all the brackets holding the three pulleys. The two main...

Finally found the problem. All the fuel lines are in good shape, the pump pumps, the filter is new, everything is OK. So I found a...

I kinda leaning toward a downed push rod jamming the crank gear to cam gear and oil pump gear but is just a guess. A tear down is the...

OK, I've run out of daylight but we're getting closer (I think). Still weird response, this is what I have: 1. With key in "RUN"...

it is staring you in the face along with serial number. 16082354 > 08 23 2016

How to align both balance shafts on a MTD 547 engine?

Post your units model and serial numbers. With them we can tell you which switch you need. Many switches look the same, but are very...

G'day guys, Further to my prior posts regarding electrical issues on my Toro zmaster 6000, it was suggested the new ignition switch i...

so I put the new belt on and did some mowing, seems to be ok so far. So what i learned from this thread is that the angled pulleys on...

Check to see if it is Lazer etched into the side of the block.

What RPM was the engine ran at, ALL the time. Idle down for warm ups? Idle down for cool off's? Low RPM's to save gas?

Hello J., When I see tap splices like that, it spells "rednecks and beer" around my area. Those things should be outlawed. Small...

I have found that the el cheapo idler arm needs replacing most of the time along the step. It is a flimsy piece of metal which why it...

I've seen these before. Yep, crookeder than a dog's hind leg and made that way at the factory. Best thing you can do is make sure you...

Hi Everyone, This is just a note for everyone regarding my experience. I wish I had more to share... I have a 2013 JD X360 that mainly...