Latest activity

  • O
    Install new oem air filter, cost a little more but will work better then some really badly made aftermarket air filters. Some are made...
  • Etbrown44
    Been a great motor. Drained tank end of last season. This season it starts fine but wants to backfire some through carb and blew air...
  • S
    slomo replied to the thread D110 Issue.
    Clean the battery post and the cable connector to fresh metal. Connect as normal. Then one can dope on grease or dielectric on the...
  • S
    slomo replied to the thread D110 Issue.
    Um, yes it will. While cranking, if the battery voltage drops to 10.5VDC or less, battery is toast. Or measured AT the starter while...
  • S
    slomo reacted to ILENGINE's post in the thread D110 Issue with Like Like.
    Either you have a bad wire connector, most commonly at the battery, but could be were the ground wire connects to the frame, or the...
  • S
    slomo replied to the thread Engine Blast.
    Visually yes, bet it looked like a new baby calf. Thermally, no. All it did was mummy wrap the cooling fins killing cooling...
  • H
    Honest Abe replied to the thread Name that mower game.
    I'll guess on this one - Cub Cadet.... and the winner is?
  • Craftsman Garage
    Craftsman Garage reacted to Rivets's post in the thread Name that mower game with Like Like.
    Looks like a Simplicity tractor. Simplicity started building NFL and NCAA branded tractors about 1996. If I remember right, I think...
  • R
    Rivets replied to the thread Name that mower game.
    Looks like a Simplicity tractor. Simplicity started building NFL and NCAA branded tractors about 1996. If I remember right, I think...
  • N
    Neo7 reacted to slomo's post in the thread Engine Blast with Like Like.
    No. It will insulate the fins causing poor cooling and over heating. Not a good idea.
  • N
    Neo7 reacted to Craftsman Garage's post in the thread Engine Blast with Like Like.
    I've used light coats of aluminum paint with great results.
  • Craftsman Garage
    Craftsman Garage reacted to shiftsuper175607's post on Craftsman Garage's profile with Like Like.
    Did you do the engine swap from the Honda 670 to another engine? I have a super Z I bought with blown Honda engine due to crank seal...
  • Craftsman Garage
    Craftsman Garage commented on shiftsuper175607's profile post.
    Yep! I swapped in a Briggs and Stratton V-Twin out of a cheap mower that I bought for parts. It was a Briggs 445677 with a 3"x1" shaft...
  • S
    shiftsuper175607 left a message on Craftsman Garage's profile.
    Did you do the engine swap from the Honda 670 to another engine? I have a super Z I bought with blown Honda engine due to crank seal...
  • Craftsman Garage
    Craftsman Garage replied to the thread Engine Blast.
    I've used light coats of aluminum paint with great results.
Top