Latest activity

It isn't like I haven't scream as loud as I can at times or gone out and shot my pond water full of 12 ga holes and then called them...

Well I see you are just throwing at it as the seat switch has nothing to do the reverse inhibit working as intended. It is just that you...

Engines need spark, fuel, and air to run. Check your spark plugs. Are they wet with gas? Do they spark? Is it getting fuel to the...

Hello Mike, Place 2X4's on each side under the outer edge of the deck housing, then lower the deck so it can rest on them Where the...

If it were my mower, I would run it level all around. If you are going to do it by the book, match your height selection to the actual...

Some on this forum will disagree, but if Op doesn't want to pay for an oem carb, he can always try amazon and ebay for about $15. If it...

Does the tensioner pulley spin freely without growling noise? Is the tensioner arm moving freely and no wobble? Is the tension spring...

Ok, I will try that, and thanks for your help.

Thanks for the quick reply. I am aware of the rod adjustment ferule but that doesn't appear to be the constraint. Rather with the rod...

If the hydrostatic transmission is solid (no leaks, smooth drive), wheels roll freely (no bearing play or grinding), and other wearing...

20% with 100psi of air put into the cylinder.

It is not aluminum, yes it is the normal gasket. And if it was me, no I would not reuse it as it is already crushed. For testing you...

You notice that threaded rod? That is for making a manual adjustment when the blade wears the ends down. Pull the clip out and turn the...

the pin MOZ425BO47OO3 when i run it if i push the control all the way forward that when it seem to be the worst

Where did you get these from? Scamazon or Fleabay? OEM parts????