Latest activity

I say hone it very lightly, then re-ring it and run it. Boring to oversize is impractical and very expensive to do in a machine shop...

StarTech, gave a good link that should help. The label was likely removed to hide that the engine had been changed in the past. People...

Thank you for the suggestion, I'll give them a look.

Look for a Julian day and year date molded/embossed into the rear tires. Not all tires had that, but many did. Usually, they would show...

I ordered a new relay and seat switch,thanks for the help!

My HG 2800s have side & top access points..

Glad you have it resolved. If there are any signs of smoke, heavy chirping or excess noise shut it down any check the idler and...

Changed the deck belt Saturday and it works as good as new.

Hi I have a Cub cadet xt1 lt 42” with a Kohler ks540 engine. When I cleaned the outer engine with carb cleaner I sprayed a little at the...

I am rebuilding this B&S snowblower engine that blow the connecting rod and scratched the cylinder and the piston also. The spec say...

Forgot to mention that after rebuilding the carb and still having the issue, I took off the carb and went through it again. Everything...

The carb bowl is built into the bottom of the carb (it's not detachable). To get to the bowl, you have to remove the top half of the...

Now pull the carb bowl off. Turn the key on. Carb needle should allow fuel into the bowl area. Get a drip pan ready. Make sure plenty of...

I pulled the engine covers and cleaned the engine & fins before changing the ignition coils 2 weeks ago.

Pumps were made by Briggs & Stratton.