Latest activity

  • S
    SamB reacted to Skippydiesel's post in the thread Oil filter with Like Like.
    "Have you done as I asked? Lay your used filter 1/3rd full on its side and observe oil leaking out or not? It will leak slowly through...
  • S
    Skippydiesel replied to the thread Oil filter.
    "Have you done as I asked? Lay your used filter 1/3rd full on its side and observe oil leaking out or not? It will leak slowly through...
  • S
    Skippydiesel reacted to ljb's post in the thread Oil filter with Like Like.
    Man, and all this started with my simple question lol.
  • S
    Skippydiesel reacted to GrumpyCat's post in the thread Oil filter with Like Like.
    As stated, Subaru OE filter (and Wix) is empty by the time I get around to removing from hot engine, 5 minutes. Avalon filter was bone...
  • S
    Skippydiesel reacted to Honest Abe's post in the thread Oil filter with Like Like.
    next up, an 80-page thesis on oil viscosity and flow rate . . . . . :unsure:
  • S
    SamB replied to the thread Oil filter.
    OK. That said, will it extend engine life to 'flush' these "resting areas" or are they best left alone? Let sleeping dogs lie, as it were?
  • A
    Auto Doc's replied to the thread Oil filter.
    Hello SamB, Nothing wrong with using a vacuum method to suction the majority of oil out through the dipstick tube. Even using the...
  • ILENGINE
    ILENGINE reacted to hlw49's post in the thread Husqv hydrostatic transmission with Like Like.
    Have you had one of the wheels off and left the key out of the axle?
  • H
    hlw49 replied to the thread Husqv hydrostatic transmission.
    Have you had one of the wheels off and left the key out of the axle?
  • S
    SamB replied to the thread Oil filter.
    You bad! But seriously, does the filter on any lawn/garden really do anything after the initial break-in period? I realize that some...
  • R
    rhkraft replied to the thread Scag tiger cub deck.
    The shaft looks like it is welded on so a nut or other arrangement must be on the other end. May have to disconnect the push rod and...
  • L
    ljb replied to the thread Oil filter.
    Man, and all this started with my simple question lol.
  • L
    ljb reacted to Honest Abe's post in the thread Oil filter with Like Like.
    next up, an 80-page thesis on oil viscosity and flow rate . . . . . :unsure:
  • A
    Hello bradcash, Look for the correct model number on the label under the seat it usually starts with "96" Have you look closely at the...
  • bradcash
    bradcash replied to the thread Husqv hydrostatic transmission.
    YTH22v46 SN 011019D008646 Thank you Not zero turn. Thanks ILENGINE
Top