Latest activity

Thanks again for your response. My deck does not have the hanging rods that are adjustable. As I mentioned earlier, my deck has the...

The deck is leveled correctly, and the tire pressure is correct. Excuse my ignorance, but I don't understand how a bushing would work...

Until I get you some pics, ....are you satisfied that the deck raise handle, it's mechanisms and rods below the seat, the cable lift...

Are you satisfied with the range/travel offered by the height adjustment lever at the side of the seat? thanks

Sorry, I only had your most recent post in view at the time of my response to you about the hole location: self drilled or not...

In the meantime, I lowered the cable pins to the lowest hole on the lift arms and that made it worse so back to square one.

Thanks Scot. My original post explains it.

Just put a new B&S engine on my SCAG. Engine is PXi2400 series Model 44U8770044G1. It has a hose barb on the side (see picture) - what...

They’re all squeezing us into screaming in pain. It’s a little game they like to call, “increase profit margins” … CEO needs a bigger...

Though I thought about drilling, there were several pre-drilled holes not being used by the factory. I'll be back to the machine...

I have read your post several times and still haven’t figured out what non-standard hole you are talking about. Did you drill a new hole?

Who put sand in the oil sump? You have more issues than one crank bearing surface. Look at all that grit inside on the parts...

My Honda Mower: Harmony II HRT216 SDA, MZCG 6092719. Manual Choke. With the throttle cable disconnected such that the inner wire can...

That looks to be beyond saving, the seal groove and aluminum scoring tells me this thing was run low on oil. Here is a used long block...

most "dry" bolts are not dry. They have oils on them from manufacturing. Dry means not dipped in a bucket of oil. As ILENGINE posted...