Latest activity

Unless the blades are gear drive or clocked with a timing belt the blades will not stay clocked and will collide

If the OP wants to use longer blades then the correct answer is, “will it fit?” No detriment if longer blades fit. How much clearance to...

That is not the number. Look at the flat vertical section opposite side of the block from the air cleaner and carburetor. They will be...

You do realize that Ferris IS2600 with a 61" Deck uses three 21" which 3 are 63" so you have up to a half an inch overlap between the...

Hi Phillybo, The manuals do not give the exact design specification for the installed height of the valve guides. If this head has a...

AMEN! In another thread I was reading, the poster ran on without a single punctuation mark or capital letter for 14 lines, all one big...

Back on modifications - was a Kansas banker in the '70s who raced SCCA - his mechanic modified his mower so that it would literally hit...

You mean "premium" as in price? Well, if you're using less per gallon of gas, but you'd need 2x+ as much of the other stuff....is the...

Do some oil filter research. That engine may not require anti-drainback valve but there's VERY likely one with same specs otherwise...

interestingly, my JD x585 has a drip tray that the engineers designed to catch the bit of oil that spills out when replacing the filter...

I run 2 old Snappers, have since '89. One's set up for mowing, other for pick up. Am on 3rd engine for mower, currently a Honda 390GXV...

Better engineering by the design engineers would help.

Some just don't get it that there is only a 1/16 overlap if 72" true cutting width which means the OP has to have prefect blades. Either...

what you talk'n 'bout Willis, can't you see MY lawn is perfectly level..... 🫣

This manual may help you out. Valve guides are above the head body. https://www.hunterlomison.com/pdfs/0C8221.pdf