Latest activity

I'm at a loss for words...cut right to the chase give as much information as one can on "said" piece of equipment.. Most of these guys...

I have both on my Kubota — foam filled fronts and liquid ballast rears. Although the fronts never go flat, they are hard and heavy. Had...

Turn it over , clean , dry . then apply a heavy coating of paraffin . A 1,500 watt heat gun or propane torch will melt a thick coating on .

if the pressures are way out of range from one another then the deck can't be level....

The bolts usually line up, but the 14HP head gasket has to match the 18HP head combustion chamber exact. If not, a gasket failure will...

Hi BWH, If the heads are as far as you have gotten and the cylinder walls & piston tops look good, leave well enough along and don't...

Ebay has quite a bit of new and used for this engine.

I have quite a number of repair book and CD's I purchased on Ebay. Search there for Briggs and Stratton Service manuals In reality, the...

I had a simular problem with a 40" Gravely deck, I slotted the mounting holes in one of the spindles to move it closer to the other...

Hello woodstover, Sorry, the gear cannot be flipped. If you replace it place a mark with paint or nail polish on it to make sure of the...

Hi .. Well after checking the coil .. cables plug etc .. there is still no spark .. Could it be the flywheel .. Or is there another...

Hi .. Well after checking the coil .. cables plug etc .. there is still no spark .. Could it be the flywheel .. Or is there another...

run it until it dies. In the meantime keep your eyes open for a good core engine. The noise could be rust on the flywheel, a loose piece...

I agree , balance is important and I use my pocket knife and know where center is . You say , how in hell does that ole man know where...

Are the bearings plain or ball? Ball bearings were introduced sometime in the 1920s to 1930s...you have to do a patent search to see who...