Latest activity
-
woodstover reacted to Chris623's post in the thread Cub Cadet just stop moving while I was mowing. with
Like.
Yes, I know the shaft can't be allowed to turn. I can handle that. I have two 13" rims from my trailer that will work nicely, I think... -
woodstover reacted to Auto Doc's's post in the thread Cub Cadet just stop moving while I was mowing. with Like.
You are correct, that is a part listing label you saw, I had to look at mine just a minute ago. The product ID label is actually on the...
-
RRevB replied to the thread Craftman 5000 Watt Generator hard Starting when Hot.I can and I did. Multi cylinder vs single is not such a stretch. Both will be down on power and the single more so but it will run at...
-
AAuto Doc's replied to the thread Briggs INTEK 22 Model 44N877-005G1 Throttle Adjustment.Refer to the actual Briggs and Stratton service information might be a start. You've added an aftermarket carburetor, played with the...
-
woodstover reacted to Oddjob's post in the thread Okay, this is going to be weird. Rear-engine goes too fast. with Like.
We all make mistakes. Except me. Just kidding. We should all graciously accept that mistakes happen, make the necessary correction...
-
woodstover reacted to slomo's post in the thread Okay, this is going to be weird. Rear-engine goes too fast. with Like.
All correct. Keep the engine at roughly 3600rpm at ALL times. This is for MAX engine cooling and lubrication. For the deck it cuts and...
-
RRevB replied to the thread Bad Boy military discount.Use what you have where you are. 👍 Used to use my JD 5303 and a Bush Hog 7 foot trailing to do an 2300 foot grass runway. Worked as well...
-
woodstover reacted to sgkent's post in the thread Briggs and Stratton Intek Plus 18.5HP How Flat does the head need to be for copper gasket? with Like.
Next time sand in an X. then flip it 90 degrees and sand in a circle, the flip it 90 more degrees and sand in an X or a +, vary the...
-
AAuto Doc's replied to the thread Briggs and Stratton Intek Plus 18.5HP How Flat does the head need to be for copper gasket?.I say don't overthink it. It's not the space shuttle. Sand the surface to true it properly, spray the gasket with copper coat and let...
-
I also call them Briggs starter c clips JESUS CLIPS. When I pry it off carefully and it goes flying high and me listening for where it...
-
“Oppy” means opposed twin. People cannot get the correct parts at their local small engine shop without a model number of the mower or...
-
You can't use a metal to replace the plastic if the flywheel gear is plastic or aluminum. It will eat up the ring then you have get a...
-
2muchgrass2mow replied to the thread Okay, this is going to be weird. Rear-engine goes too fast..P.S. You’ll never sell it if a potential buyer gives it a tryout! I’d forget about that option. I had a Craftsman 12.5 hp version of... -
2muchgrass2mow reacted to Oddjob's post in the thread Okay, this is going to be weird. Rear-engine goes too fast. with Like.
We all make mistakes. Except me. Just kidding. We should all graciously accept that mistakes happen, make the necessary correction...
-
2muchgrass2mow replied to the thread Okay, this is going to be weird. Rear-engine goes too fast..VFP: There is a mechanical lift called a “Mojack” that allows you to raise the front of your mower up about 45 degrees. I have had one...