Latest activity

Reporting back for future HRZ216 owners with similar issues that find this thread. Happy to report I figured out the issue. The problem...

To remove the lingering doubt, have the local shop do a warranty check over and test run, they can file it under a customer satisfaction...

@ILENGINE, I'm no expert in the matter. I'm not a petroleum engineer. I AM an engineer (electrical) and a gearhead (my dad was a...

1. fuse is new and tested good battery connections are clean and tight battery voltage is 12.88 2. voltage is 12.88 3. purple wire is 8...

Mine might be that old I have no idea it was pretty much gifted to me as junk and then I brought it back to life. And that was say more...

Not the greatest picture but may be able to blow it up and see how everything is sitting https://a.co/d/ePKyaFv

My LT1000 42" is from 2005 so quite different than yours. But I'll say that I wear ear protection radio headphones to protect my ears...

Resolution?! Went out to the barn intending to do whatever was needed to get the mower started, sat down, grabbed the key, gave it a...

@GearHead36 I don't know if it was a proven fact or some word of mouth that spread about, with the original reason being trying to...

Ok, I have the seal "seated", now I am looking at the shaft itself "internal" where the e-clips are attached...does the shaft sit on...

I'm having a hard time understanding how this could be. I'm not saying that it's impossible, but I'd like to see proof. I hope that's...

I'm a big fan of getting the right machine for a given property. I usually change my equipment every time I move. Sounds like you got...

Thanks for the wise advice. I thought about this long and hard since my initial post. I did the rough napkin math on estimated repairs...

No. Just close enough to the edge that I had to physically pull it back. Here's the sequence of events: I turned off the mower, put on...