Latest activity

i didnt know the fx 730 was one inch shaft. that would be a good replacement assuming the shaft length is the same. is there any work...

Ok now. You have a bad switch somewhere. Seat switch is 2 wires, jump across harness, try to start. if no start jump Brake switch same...

Make sure the tensioner pivot is not rusted and pulling all the way off. If not the brake pads will never touch spindle pullies. If...

Make sure the tensioner pivot is not rusted and pulling all the way off. If not the brake pads will never touch spindle pullies. If...

Sounds like float is getting stuck someplace with float bowl, causing needle not to work correctly. Maybe you should just get new carb?

Only purchase the tank from a 4/5 star rating seller. I've had same problem. Cheaper is just cheap. Good rating good product.

Nice to read that your running again.

ok, use a vac/fuel pressure gauge at fuel pump and test positive and negative readings. Pulse line should show 1 1/2 lbs. or more, suck...

I never saw this before but I understand what it says. I basically did tighten in this order. I will allow go to the 250 in/lbs when...

Sounds like Coil going bad. Insulation breaking down with Heat. It's happened to me a couple of times with Briggs engines, they would...

My Sympathys: I have been trying to figure out why the (white) "trigger" connector has 12 v when the key is turned to start, however...

This manual has a wiring diagram which may help you out. https://www.thepowerportal.com/ipls/ipl.htm?md=42544x8E~_IPLURL_LO.pdf

My Sympathys: I have been trying to figure out why the (white) "trigger" connector has 12 v when the key is turned to start, however...

My Sympathys: I have been trying to figure out why the (white) "trigger" connector has 12 v when the key is turned to Start yet it won't...

I haven't heard of this problem on a Husqvarna but it fairly common on the Cub Cadet lawn tractors. The vent on the fuel cap may be...