Latest activity

Drive motion was working as it should before the belt broke. I have printed off a copy of the manual and will look through it again...

I have a John Deere D125. 9 years old. About 250 hours on it. It broke the deck belt. I replaced the PTO cable as old one was...

Just installed the 596505 carburetor and I think it fixed my sputtering over bumpy uneven terrain. I have to do a full mow to make sure...

How was the drive motion acting before you changed the drive belts. I seen a owners manual/parts list download at the sears link...

that clicking noise is a low battery

The problem isn't the carb the problem is the absolutely junk fuel. Since Briggs came out with this engine in 2015 the biggest issue...

I am looking for idler pulley GC00674 and Transaxle AM131850 - is there a replacement or a way to fix issue with drive shaft from...

Is the float valve rubber/Viton in good condition? I there any fuel "varnish" , other crap, on valve tip/valve seat? 😈

1. Try a mini inline valve with barbs + short fuel line. There are very compact inline shutoff valves made for tight spots—some are less...

Heck! don't change the oil until the engine locks up. LOL I've seen that happen before.... New oil and filter, but the engine locked solid.

Hmm, reading the operator manual must have been more than the owner could stand.

Agreed! :devilish:

Actually the small wire ring is suppose to slip over the fuel line install the fuel filter and then slip the wire ring down over the...

Is the float valve rubber/Viton in good condition? I there any fuel "varnish" , other crap, on valve tip/valve seat? 😈

All zero-turns.