Latest activity

How did you plastic weld it?

Yes, your right for the pre-mix fuel Thank you

That wood not work with the Stihl chain saw easy start.

The little cable assembly is for grabbing the hose end once it is forced through the tank grommet, that way the filter can be put on the...

Hello Meridian28, First question is the bearing correct? If so.... Polish the outer surface of the pulley fit area for the bearing...

Hello Trout bum, The belt guides for the crank pulley need to be close to the outside of the pulley to prevent the belt from jumping...

I tried to reply to the no compression issue on one cylinder earlier, but my reply disappeared somewhere. Anyway, the engine likely...

Hi motormike, The reason for the air shrouds is to concentrate air around and through the cooling fins of the cylinder(s). The flywheel...

This winter I purchased for a well cared for Super Bronco with a bad Kohler motor and I replaced the bad Kohler with a good one from an...

I have a Honda HRX217. I had to use a press to get the pulley off the upper roto-stop assembly. Should it be that tight of a fit? The...

Thanks guys!

Thanks guys!

Back to the Murray problem, I did a compression test today. Cylinder 1(left) 0 psi, cyl. 2(right) 110 psi. Suggestions?

Well, the blasted thing is acting up again. I put a Shindy kit in the original carburetor and intend to install it tomorrow. My plan is...