Latest activity
-
7394 replied to the thread Armrest Mounts?.Fan screen is oversized to help prevent sucking in debris... -
Those plastic fasteners [92039] are supposed to removable and usable. Just pry up the center pin to release them. Under that plastic...
-
Did you remove the debris screen screws and debris screen?
-
FForest#2 replied to the thread Website slow.Yes. (very slow or no go. I had to copy/paste my post into word and then come back couple hours later and try again. By saving to word...
-
FForest#2 replied to the thread Turf Tiger II model model-sttii-61v-37bv-efi blows 20a fuse after mowing for 15-30 minutes.Read post #10 again. Install a 7-10 amp fuse in the pto lead and test. Also look at the existing fuse holder carefully. I've seen fuse...
-
FForest#2 replied to the thread Customer states, hit a stump and now deck is making terrible noises.Some people (several) should not be allowed to even own a mower much less try to operate one.
-
MMParr replied to the thread Customer states, hit a stump and now deck is making terrible noises.🤣🤣🤣
-
MMParr reacted to Honest Abe's post in the thread Customer states, hit a stump and now deck is making terrible noises with
Like.
tell the customer she killed the machine and sell her a new one. Serves her right . . . . . -
MMParr reacted to Its Me's post in the thread Customer states, hit a stump and now deck is making terrible noises with Like.
looks like some duct tape and sharpen would not cure, that is an example of a person who should not won a mower.
-
MMParr replied to the thread Reline mower clutch.You can buy Ox and Xtreme clutches a little less than the Warner.
-
MJust for those reading this, the washer is a Belleville type that is cup shaped. The concave side goes toward the shaft the convex side...
-
UGood Day!! I was just wondering if anyone has found a place to buy the friction material to reline the mower clutch? we used to do this...
-
-
AAuto Doc's replied to the thread No oil pressure Kohler CH20 64632.At the very least I recommend you polish the crank journals with some fine mechanic sanding cloth and verify there is no aluminum...
-
AAuto Doc's replied to the thread No oil pressure Kohler CH20 64632.At the very least I recommend you polish the crank journals and verify there is no aluminum transfer from the components running dry. If...
-
TTrimmerparty replied to the thread Running rich on my Dixie chopper.Removed and disassembled the Nikki OE4215. Found the nozzle gasket had crushed to the point the orifice’s were blocked by gasket material.
